Rotary Shoes

Type A

This shoe is used to size and dress the top of a fish inside the casing. It makes a tapered cut on the fish with out damaging the case and cuts on the I.D., O.D. and bottom.

Type B

Is used in open hole for washing over and cutting formation, metals or cement with limited inside clearance. It cuts on the I.D., O.D., and bottom.

Type C

Is used to cut metal on the fish with no damage to the casing. It cuts on the I.D., and the bottom.

Type D

Is used for washing over and cutting formation only. It cuts on O.D. and bottom only.

Type E

Is used for washing over and cutting formation only. It cuts on the bottom, but not on the I.D., and O.D.

Type F

Is used inside casing for washing over and cutting on the bottom only. It does not cut on the I.D. or the O.D.

Type G

Is a low torque type shoe used for cutting metal, formation, or cement in the open hole. It cuts freely on the I.D., O.D., and bottom.

Type H

Is a drag type shoe used to cut soft formation, or when running weak string. It cuts on the bottom only.

Type I

Is a low torque type of shoe used inside casing to wash over and cut on the bottom only avoid damages to the casing or fish.

Type J

Is used to cut metal on the fish without damaging the casing. It cuts on the bottom and on the I.D. only.

Type K

Is used to open hole for washing over and cutting metal and cement with limited inside clearances. It cuts on the bottom and O.D.

Type L

Is used for washing over and cutting metal, formation, or cement. It cuts freely on the I.D., O.D and bottom.

Type M

It cuts metal on the fish without damaging the casing because it does not cut on the O.D. It cuts on the I.D. and bottom only.

Type N

Is used in open hole with limited outside clearance to cut metal or cement and a limited amount of formation without damaging the fish. It cut on O.D. and bottoms only.